Olimex STM32-P207

The NuttX configuration for the Olimex STM32-P207 is assembled mainly from the configurations stm32f4discovery and stm3240g-eval.

It was tested with the NuttX EABI “buildroot” Toolchain.

Debugging with OpenOCD via an Olimex ARM-USB-TINY-H works. Note that CONFIG_DEBUG_SYMBOLS and CONFIG_STM32_DISABLE_IDLE_SLEEP_DURING_DEBUG are enabled so that the JTAG connection is not disconnected by the idle loop.

The following peripherals are enabled in this configuration.

• LEDs: show the system status

• Buttons: TAMPER-button, WKUP-button, J1-Joystick (consists of RIGHT-, UP-, LEFT-, DOWN-, and CENTER-button). Built in app ‘buttons’ works.

• ADC: ADC1 samples the red trim potentiometer AN_TR Built in app ‘adc’ works.

• USB-FS-OTG: Enabled but not really tested, since there is only a USB-A-connector (host) connected to the full speed STM32 inputs.

• USB-HS_OTG:The other connector (device) is connected to the high speed STM32 inputs (not enabled).

• CAN: Built in app ‘can’ works, but apart from that not really tested.

• Ethernet: Ping to other station on the network works.