olimex-lpc2378

The Olimex LPC2378 board has only a small amount of board-specific porting information recorded in the original notes.

Board Notes

• EXT1: P3[0:7] are used for LEDs.

• UEXT pins 3 and 4 provide TXD2 and RXD2 for UART2.

Known Limitations

The board used for this port still had the - LPC2378 revision, even though it was purchased more than two years after the updated chip revision was released. With that hardware, NuttX would not run correctly with the MAM fully enabled.

Console Setup

Testing was done with an FTDI ft232 USB-to-serial adapter and NSH piping, as shown in the original board screenshot.