Olimex STM32-P207

The NuttX configuration for the Olimex STM32-H405 is based on the configuration Olimex STM32-P207.

It was tested with the NuttX EABI “buildroot” Toolchain.

Debugging with OpenOCD via an Olimex ARM-USB-TINY-H works. Note that CONFIG_DEBUG_SYMBOLS and CONFIG_STM32_DISABLE_IDLE_SLEEP_DURING_DEBUG are enabled so that the JTAG connection is not disconnected by the idle loop.

Make sure that ‘# CONFIG_NSH_CONDEV is not set’ is in the .config file - it defaults to ‘/dev/console’ which makes problems with the shell over USB.

The following peripherals are enabled in this configuration. - LED: Shows the system status

• Button: Built in app ‘buttons’ works.

• ADC: ADC1 samples ADC_IN1. Built in app ‘adc’ works.

• USB-FS-OTG: The console is running on the virtual serial port. Note that you have to press enter three times until NSH appears.

• CAN:Built in app ‘can’ is enabled but not tested, since no CAN transceiver is on board.