Nordic nPM1100 battery charger

Nordic nPM1100 PMIC charger status, enabled with CONFIG_NPM1100 (needs CONFIG_BATTERY_CHARGER).

The chip has no register interface. Charge and error state come from its open-drain, active-low CHG and ERR pins, which the board reads through two callbacks:

#include <nuttx/power/npm1100.h>

struct npm1100_config_s
{
  CODE bool (*read_chg)(void);  /* CHG pin level, low = charging */
  CODE bool (*read_err)(void);  /* ERR pin level, low = error */
};

FAR struct battery_charger_dev_s *
  npm1100_initialize(FAR const struct npm1100_config_s *config);

The returned instance is registered with battery_charger_register(). BATIOC_STATE reports BATTERY_CHARGING, BATTERY_IDLE or BATTERY_FAULT; BATIOC_HEALTH reports BATTERY_HEALTH_GOOD or BATTERY_HEALTH_UNSPEC_FAIL. Voltage, current and operate requests are not supported.