================= Microchip pic32mz ================= Microchip PIC32MZEF ------------------- (MIPS M5150 architecture). A port is in available for the MikroElectronika `Flip&Click PIC32MZ `__ development board based on the PIC32MZ2048EFH100 MCU. This board configuration was added in NuttX-7.24 and is, for the most part, compatible with the PIC32MZEC family. **STATUS:** **NuttX-7.9**. The first official release was in NuttX-7.9. Many drivers port simply from the PIC32MX; others require more extensive efforts. Driver status as of (2015-03-29) is provided below: - I/O ports include I/O port interrupts - UART serial driver that provides the NSH console, - Timer, - I2C (untested), - SPI (untested), - On-board buttons and LEDs, - Ethernet (code complete, but not yet functional), **NuttX-7.29**. Abdelatif Guettouche contributed additional timer support including: Timer lower half driver, free-running, and one-shot timers. **NuttX-7.31**. Abdelatif Guettouche contributed DMA support. **NuttX-9.0**. Cache operations were implemented. Refer to the NuttX board `README `__ file for further information. **Development Environment:** Same as for the PIC32MZ. Microchip PIC32MZEC ------------------- PIC32MZEC Family (MIPS microAptiv). A port is in available for the PIC32MZ Embedded Connectivity (EC) Starter Kit. There are two configurations of the Microchip PIC32MZ EC Starter Kit: #. The PIC32MZ Embedded Connectivity Starter Kit based on the PIC32MZ2048ECH144-I/PH chip (DM320006), and #. The PIC32MZ Embedded Connectivity Starter Kit based on the PIC32MZ2048ECM144-I/PH w/Crypto Engine (DM320006-C). See the `Microchip `__ website for further information. This was a collaborative effort between Kristopher Tate, David Sidrane and myself. The basic port is functional and a NuttShell (NSH) configuration is available. Supported Boards ================ .. toctree:: :glob: :maxdepth: 1 boards/*/*